With the continuous development and popularization of electronic products, solder point lamp bead sealing protection glue, as one of the key components of electronic products, plays a very important role. However, in the process of using this protective glue, many people may encounter the situation of avoiding the protective glue. So what should we do? Today we are going to introduce this problem and the solution.

 The reasons for sealing to protect glue are as follows:

1. The sealing depth is too deep, with strong sealing ability, and no curing conditions.

2. The contact material is special, which makes the curing agent ineffective.

3. Requirements for curing speed is fast, and ordinary glue is difficult to achieve.

 There are some ways that we can take to solve these problems:

1. Adjustment process: use the glue system that can be cured without touching the air.

2. Choose the glue with stable quality: choose the glue that can not be affected by most materials.

3. Choose the glue with double curing and even multi-curing process ENIENT EGO530: Choose the glue that can be mixed, room temperature, heating and other curing methods, so that the curing speed can be flexibly adjusted to meet the requirements of high efficiency.

 In addition, the new formula of silicone rubber 30 minutes curing depth of 20cm of the new protective glue, can well solve the problem of the protective glue. This protective glue uses the latest silicone rubber formula, the curing time only takes 30 minutes, the curing depth can reach 20cm, not only to ensure the curing effect of the glue, but also improve the production efficiency, is the best choice for solder point lamp bead sealing protective glue.

 In short, it is a common problem to protect the glue, but we can solve this problem well by adjusting the environmental temperature and humidity, paying attention to the use method and checking the quality of the protective glue. At the same time, we can also choose the new silicone rubber formula curing depth of 30 minutes of 20cm of the new protective glue, to improve the curing effect and production efficiency. I hope you can encounter less trouble in the process of using the solder joint lamp beads to seal the protective glue, and produce higher quality electronic products.