ENIENT EJ0306 Transparent protective coating silicone is low viscosity single component room-temperature curing silicone coating.
APPLICATION
· Suitable for coating protection of thick film circuit system, porous substrate and printed circuit board.
PERFORMANCE
·
Superior performance: Form a tough and wear-resistant protective film.
·
Cure condition: It can be cured at room temperature or accelerated by heating. (suggested temperature less than 60℃).
·
UV Indicator: The use of an Ultra Violet light instantly allows you to see any
areas without any EJ0306 protection.
PEOPERTIES
| Appearance |
Fluid |
| Viscosity(cps) |
1000 |
| Colour |
Clear |
| Tack-free time (25℃.1mm) |
10min |
| Specific gravity |
1.50~1.15 |
| Hardness (shore A) |
78~88 |
| Tensile strength (MPa) |
2.5 |
| Elongation at break % |
50 |
| Volume resistivity (Ω·cm) |
≥2.5×1014 |
| Dielectric strength (kV/mm) |
≥13 |
| Dielectric constant |
≤2.5 |
INSTRUCTIONS
· Preproccess: the surface of the substrate shall be degrease, clean and dry, leave no dust and dirty.
· Treatment: apply an appropriate amount of the product evenly on the surface to be covered. You can choose spraying, flow coating, infiltration, brush coating and other processes.
· Curing: expose the covered work-piece to air for curing.
